Previous   Next   Contents       (Exim 4.40 Specification)

12. Embedded Perl

Exim can be built to include an embedded Perl interpreter. When this is done, Perl subroutines can be called as part of the string expansion process. To make use of the Perl support, you need version 5.004 or later of Perl installed on your system. To include the embedded interpreter in the Exim binary, include the line

  EXIM_PERL = perl.o

in your Local/Makefile and then build Exim in the normal way.

Access to Perl subroutines is via a global configuration option called perl_startup and an expansion string operator ${perl ...}. If there is no perl_startup option in the Exim configuration file then no Perl interpreter is started and there is almost no overhead for Exim (since none of the Perl library will be paged in unless used). If there is a perl_startup option then the associated value is taken to be Perl code which is executed in a newly created Perl interpreter.

The value of perl_startup is not expanded in the Exim sense, so you do not need backslashes before any characters to escape special meanings. The option should usually be something like

  perl_startup = do '/etc/'

where /etc/ is Perl code which defines any subroutines you want to use from Exim. Exim can be configured either to start up a Perl interpreter as soon as it is entered, or to wait until the first time it is needed. Starting the interpreter at the beginning ensures that it is done while Exim still has its setuid privilege, but can impose an unnecessary overhead if Perl is not in fact used in a particular run. Also, note that this does not mean that Exim is necessarily running as root when Perl is called at a later time. By default, the interpreter is started only when it is needed, but this can be changed in two ways:

There is also a command line option -pd (for delay) which suppresses the initial startup, even if perl_at_start is set.

When the configuration file includes a perl_startup option you can make use of the string expansion item to call the Perl subroutines that are defined by the perl_startup code. The operator is used in any of the following forms:

  ${perl{foo}{argument1}{argument2} ... }

which calls the subroutine foo with the given arguments. A maximum of eight arguments may be passed. Passing more than this results in an expansion failure with an error message of the form

  Too many arguments passed to Perl subroutine "foo" (max is 8)

The return value of the Perl subroutine is evaluated in a scalar context before it is passed back to Exim to be inserted into the expanded string. If the return value is undef, the expansion fails in the same way as an explicit “fail” on an ${if ...} or ${lookup...} item. If the subroutine aborts by obeying Perl's die function, the expansion fails with the error message that was passed to die.

Within any Perl code called from Exim, the function Exim::expand_string is available to call back into Exim's string expansion function. For example, the Perl code

  my $lp = Exim::expand_string('$local_part');

makes the current Exim $local_part available in the Perl variable $lp. Note those are single quotes and not double quotes to protect against $local_part being interpolated as a Perl variable.

If the string expansion is forced to fail by a “fail” item, the result of Exim::expand_string is undef. If there is a syntax error in the expansion string, the Perl call from the original expansion string fails with an appropriate error message, in the same way as if die were used.

Two other Exim functions are available for use from within Perl code. Exim::debug_write(<string>) writes the string to the standard error stream if Exim's debugging is enabled. If you want a newline at the end, you must supply it. Exim::log_write(<string>) writes the string to Exim's main log, adding a leading timestamp. In this case, you should not supply a terminating newline.

Previous  Next  Contents       (Exim 4.40 Specification)